General questions
-Please refer to our YouTube videos. We have step-by-step tutorials
-Technical Data Sheets (TDS) on our website have application instructions as well
-Personal preference
-Each application gives a different finish
-Always do a test area first
Brush:
-We do not recommend using a brush
Roller:
-3/8-inch nap roller
-Make sure to de-lint it first with tape, so fuzzies do not get on the surface
Sprayer:
-Handheld Hudson sprayer, backpack sprayer, airless sprayer, pump sprayer.
-Anything with a CONE tip. NO FAN TIPS- they leave streak marks
-We recommend cleaning the day before, that way you can come in the next day and see any spots you missed.
-Stain & Seal next day
*For Cleaners, Stains, and Sealers:
-We always recommend 2 coats
-You can do 3 for a heavier color
-You can do 1 for a lighter color
-It is personal preference
-30 mins or so. It depends on the temperature.
-As long as the surface is dry, you can apply the next coat.
-Approximately 1 hour after staining.
-As long as the stain is dry, you can apply sealer
-Each gallon’s coverage includes 2 coats
-No. Penetrating sealers cannot go over stains.
-Must be used alone
-No. We recommend lighter applications because color can always be built up.
Other questions
-Removes grease, oil, calcium, and efflorescence from the surface
-Opens up the pores of the concrete to accept the stain
-Can do it 3-4 times to make your concrete look sandblasted
-90% of the job is cleaning! You must clean with any of our cleaners since it works as a system with our stains.
-It is worth it to prepare the surface properly so no issues come up after you’ve already stained and sealed.
-Concrete needs at least 28 days to fully cure
-No. Even brand new concrete needs to be cleaned!
-No. All concrete surfaces must be cleaned before staining and sealing.
-It doesn’t matter if it’s never been stained, there can still be calcium or efflorescence sitting deep inside that needs to be cleaned out, or it will come up later
-All of our products come ready to go except for our concentrated product lines.
-Make sure to read the product’s TDS for detailed mixing and application instructions. Visit our YouTube channel to watch step-by-step tutorials.
-No, never mix stains together.
-You can absolutely spray 2 colors, as long as they are dry in between applications
-If you have 2 of the same colors, we always suggest you mix both gallons together for even pigmentation.
-Color sits on the bottom of the gallon
-Go over how to mix product properly:
- Pour 80% out into a 5 gal bucket.
- Close the gallon and shake the remainder of the product very well
- Pour the rest into the bucket and mix thoroughly with a drill and mixing paddle
- Pour back into gallon with a funnel or into a pump sprayer.
-Use Classic Paint and Sealer Remover, then pressure wash off
*Must use our concrete cleaner after because the stripper is oil-based
-No, you cannot use a hose because it is not powerful enough. You must use a pressure washer